| The vibrational spectrum of the Enlightenment, or espionage |
| The noises |
| The language (NF))
The tent of the President the telephone booth |
| The high-frequency signals - General - |
| The high-frequency signals
slow signals |
| The high-frequency signals
optical signals |
| The high-frequency signals
- communication - Radio communication networks - Directional radio - Satellites - Direct coupling |
| The heat signals Thermal radiation/air-gap |
|
The high-frequency signals of the light Fiber |
| The X-ray radiation and higher ... |
| Author: Old Gocs - All rights reserved - Berlin, August / September 2013 |
Translations to the illustration
Light waves
The methods of
the information spying are based on the usage of the physical effects at
the production, the assignment, the reinforcements of the light signals
until the reception and the following transformation in electrical
signals.
The previous examples were based on the
technology of the coupling. But there are also other methods around to
take to the light signals.
The following example is based on the
insertion technology.
It was installed successfully in a glass
fibre connection. Nearer information.
At this insertion technology one uses visual
mirrors for the Umlenkung of the photon beam ((the initial fibre (1) )
on a primary mirror ( 5 ), this one the signal to the entrance coupling
fibre (3) heads off the photon beam. The primary energy share is steered
to the passive reflector ( 6 ). By the reflection at the passive
reflector the photon beam is reflected on the
glass body ($). Here the beam reaches the exit fibre (2) and can be
passed on to the receiver with that.
A very large portion of the initial energy is
reflected by the coupler into the exit fibre. Only a relatively small
portion is diverted into the decoupling fibre. This energy share has to
be regarded as an insertion loss.

In principle, applies to the attack on a
fibre optic system:
E empf = E E send - E insertion muffle - a lower limiting value is for E
empf > E empf
E empf = reception energy at the sensor; E send energy of the LED =; E
muffle line attenuation =;
E insertion = energy losses by the insertion of the decoupling
facilities