Homepage Cyberwar Cybersecurity Cyberspace C-Spionage C-Sabotage Gefährdung Kriminalität Computer Kommunikation mod. Systeme Der Mensch Beratung Bildung Fachberichte Information Kryptologie Emission Verschlüsselung Forschung Begriffe Recht Technik Verschiedenes
Cyber espionageEspionage strategyespionageEconomic EspionagefrequencyCyber spies /Hacker
The vibrational spectrum of the Enlightenment, or espionage

The noises

The language (NF))
The tent of the President
the telephone booth

The high-frequency signals
 
- General -

The high-frequency signals
slow signals

The high-frequency signals

optical signals  

The high-frequency signals

- communication

- Radio communication networks
- Directional radio
- Satellites
- Direct coupling

The heat signals

Thermal radiation/air-gap

The high-frequency signals of the light
Fiber

The X-ray radiation and higher ...

Author: Old Gocs
   - All rights reserved -
Berlin, August / September 2013

Translations to the illustration:

turned coupling
principle representation
information leading fibre
from coupled light waves
deutsch english
Light waves

The methods of the information spying are based on the usage of the physical effects at the production, the assignment, the reinforcements of the light signals until the reception and the following transformation in electrical signals

The case of the coupling became behandelt. at one "degrees fibre" on the previous side.

The photons move tangentially within the light wave conductor in the axis of the light wave conductor. However in this case the fibre is bent. This bend changes the light beam. The light, however, does not lean with the bend of the fibre interval but becomes change his career into small. The light beam pushes is what not called a different one by the bend of the fibre to the Wandung the same, is so he pushes a part of the energy according to the angle of incidence reflected after a short stretch of road repeated to the Wandung and it happens the same procedure.
Depending on which Reflektionsgrad the fibre shows, photons can be transferred to "angekoppelte fibres" with same Brechungsindexs.
Since the number of pushes on the Faserwändes at bends reaches or can reach a very high value, a successful starting-point offers himself here for the decoupling of the light signals ..

The bends of the fibres also therefore lead to an additional recession. The fibre with a strongly reflective material is covered this appearance tempted one to handle that, this. This method is practicably leads, however, for a costs and material waste in the totality since the bends cover only an insignificant length section of the cable. Or through this one according to construction of the cable
( Combination of many fibres in a cable. ) The glass fibre fundamentally reduces so that a bend the cable.



In principle, applies to the attack on a fibre optic system:

E empf = E E send - muffle - E decouples - E bend recession a lower limiting value is for E empf > E empf

E empf = reception energy at the sensor; E send energy of the LED =; E muffle line attenuation =; E bend recession = additional energy losses by bends of the fibres; E decouples energy losses = by the decoupling facilities